United Process Versapro Betriebsanweisung PDF herunterladen (Seite 46)

46 Important Product Information

GFK-1671P

Open Issues and Problems

Miscellaneous Issues

ID Description

CR74577

Grid Repainting issue when opening and closing many windows within VersaPro.

Details: If you open and close approximately 2200 or more windows within VersaPro, you

may notice that grids in certain Windows will not be re-drawn particularly if the window is

made larger.

Resolution: You can make the window smaller or close and re-open VersaPro.

CR75277

VersaPro doesn’t ensure that AUP file used with VersaMax CPUE05 or CPU374 is at or

less than 4KB or 12KB respectively in size for store.

Details: The maximum AUP size that will be accepted and used by the CPUE05 and CPU374

are 4KB and 16KB respectively. VersaPro will not warn you that the file is larger than this

limit when storing the file to the PLC. The PLC will either generate a fault or error if this is

attempted.

Resolution: When preparing an AUP file to store to the CPUE05 or CPU374, you should use

Windows Explorer to check the size of the file. If the size of the file is greater than the

prescribed limit, you should edit the file to reduce the size to less than or equal to the limit

before attempting to store the file to the PLC.

Password/OEM Key/Access Level Issues

ID Description

CR72614

Access Level 2 does not allow store of stored/override values.

Details:

1) Open any folder and connect to PLC

2) In status dialog, set access to level 2 (Write data level)

3) Do a store of Stored/Override values only

An error message will be presented “Store Error 0x0200-Insufficient Privilege Level” Stored

values should be allowed at level 2 but overrides require access level 3. This is also an issue

with Logicmaster since it does not allow selection of stored values and overrides separately.

Resolution: The access level must be set to level 3 or higher in order to store stored/override

values.

A locked block can be unlocked even if a character is typed wrongly

Details:

1) Edit/View Lock an LD or IL block using the Edit->Properties->Block->Lock dialog

2) Now when Unlocking the locked block, type the 4

character wrong.

The block gets unlocked. This may even happens with other letters in the password depending

on the length of the password.

Resolution: A password of 3 characters should be used to lock a block.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52

Keine Kommentare

United Process Versapro Betriebsanweisung Seite 46